蒽醌修饰石墨毡电极预处理头孢合成废水

以钛涂钌电极为阳极、自制蒽醌修饰石墨毡电极为阴极,对头孢合成废水(COD=25 000~30 000 mg/L、ρ(NH3-N)=850~1 300 mg/L、色度为2 300~2 680度)进行了电化学氧化预处理,优化了电解条件,并对电化学体系的动力学和稳定性进行了分析。实验结果表明:蒽醌的存在可改善电化学氧化降解效果;在电解时间50 min、电流密度0.14 A/cm2、Na2SO4浓度0.1 mol/L、极板间距2 cm、初始废水p H 7.0的条件下,废水的COD、色度、NH3-N的去除率分别可达45.3%,66.9%,33.6%;BOD5/COD由处理前的0.27增至0.40,可生化性得到改善;COD、色度、NH3-N的电化学氧化降解过程均近似符合一级动力学方程;且该电化学体系的应用稳定性良好。     

污泥加热预处理对中温厌氧消化的影响

对污泥加热预处理给中温厌氧混合消化和污泥单独消化带来的影响进行了研究.研究结果表明,污泥加热预处理有利于提高混合消化对 COD 的去除率,尤其是 SCOD 的去除率由 77%增长到 93%,但不利于 TS 和 VS 的去除;而对污泥单独消化,预处理则不利于有机物的去除.采用加热预处理后的污泥进样,混合消化和污泥单独消化的甲烷产气量均有所提高.     

Kitchen waste valorization through a mild-temperature pretreatment to enhance biogas production and fermentability: Kinetics study in mesophilic and thermophilic regimen

Biowaste valorization through anaerobic digestion is an attractive option to achieve both climate protection goals and renewable energy production. In this paper, a complete set of batch trials was carried out on kitchen waste to investigate the effects of mild thermal pretreatment, temperature regimen and substrate/inoculum ratio. Thermal pretreatment was effective in the solubilisation of macromolecular fractions, particularly carbohydrates. The ability of the theoretical methodologies in estimating hydrogen and methane yields of complex substrates was evaluated by comparing the experimental results with the theoretical values. Despite the single batch configuration, a significant initial hydrogen production was observed, prior to methane yield. Main pretreatment effect was the gain in hydrogen production; the extent was highly variable according to the other parameters values. High hydrogen yields, up to 113 mL H2/g VSfed, were related to the prompt transformation of soluble sugars. Thermophilic regimen resulted, as expected, in faster digestions (up to 78 mL CH₄/gVS/day) and sorted out pH inhibition. The relatively low methane yields (342–398 mL CH₄/g VS_fed) were the result of the consistent lignocellulosic content and low lipid content. Thermal pretreatment proved to be a promising option for the enhancement of hydrogen production in food waste dark fermentation.     

Identification of potential electrotrophic microbial community in paddy soils by enrichment of microbial electrolysis cell biocathodes

Electrotrophs are microbes that can receive electrons directly from cathode in a microbial electrolysis cell (MEC). They not only participate in organic biosynthesis, but also be crucial in cathode-based bioremediation. However, little is known about the electrotrophic community in paddy soils. Here, the putative electrotrophs were enriched by cathodes of MECs constructed from five paddy soils with various properties using bicarbonate as an electron acceptor, and identified by 16S rRNA-gene based Illumina sequencing. The electrons were gradually consumed on the cathodes, and 25%–45% of which were recovered to reduce bicarbonate to acetic acid during MEC operation. Firmicutes was the dominant bacterial phylum on the cathodes, and Bacillus genus within this phylum was greatly enriched and was the most abundant population among the detected putative electrotrophs for almost all soils. Furthermore, several other members of Firmicutes and Proteobacteria may also participate in electrotrophic process in different soils. Soil pH, amorphous iron and electrical conductivity significantly influenced the putative electrotrophic bacterial community, which explained about 33.5% of the community structural variation. This study provides a basis for understanding the microbial diversity of putative electrotrophs in paddy soils, and highlights the importance of soil properties in shaping the community of putative electrotrophs.     

2-丁烯醛生产废水的臭氧脱毒预处理

CMW（crotonaldehyde manufacturing wastewater,2-丁烯醛生产废水）污染物浓度高、毒性强、直接采用生物法处理难度大.为了降低CMW的生物处理毒性,采用臭氧氧化法对CMW进行脱毒预处理,并通过考察不同臭氧氧化条件对废水COD_Cr、TOC（总有机碳）、UV_{254 nm}去除率及SMA（specific methanogenic activity,比产甲烷活性）抑制率的影响,获得了优化的臭氧氧化条件,进一步分析了废水脱毒机理.结果表明:①优化的臭氧氧化条件为接触反应时间180 min、初始pH 3.0、反应温度35℃、气相臭氧浓度30.3 mg/L,进气流量500 mL/min;并且在该条件下,CMW中COD_Cr、TOC和UV_{254 nm}的去除率分别为19.9%、9.9%和70.6%,主要特征有机污染物[包括2-丁烯醛、（E,E）-2,4-己二烯醛、3-（2-甲基-2-丙烯）-5-戊内酯、1,5-二甲基-1-烯-4-羰基-环氧己烷、山梨酸乙酯等]的去除率在74.4%以上.②厌氧产甲烷毒性试验结果显示,CMW的SMA抑制率由臭氧氧化前的82.0%降至臭氧氧化后的47.2%.③反应动力学研究显示,CMW中COD_Cr、TOC及UV_{254 nm}的去除过程均符合一级反应动力学方程,R2分别为0.82、0.97、0.94.研究显示,臭氧氧化预处理可以较好地去除CMW中的特征有机污染物,降低废水的厌氧生物处理毒性,是一种可行的脱毒预处理方法.      

柴油机尾气中PAH_s的分析

本文概述了柴油机尾气中ＰＡＨｓ的分析方法，着重论述了采样及预处理方法，特别对预处理方法进行了深入的探讨。另外，通过对柴油机两种不同工况下产生的尾气进行分析后发现，柴油机转速越高，其排放尾气中ＰＡＨｓ的含量就越低。     

电解-CASS工艺处理制药废水工艺研究与设计

采用电解 CASS工艺处理制药厂废水 ,实现了处理效率高 ,占地面积小 ,工程投资低等优点 ,处理后各项污染指标均达到国家《污水综合排放》(GB8978— 1996)的二级排放标准     

铁炭内电解法处理染料废水的试验

文章采用铁屑一活性炭内电解法作为光合细菌生化处理染料废水的预处理方法，考查了3个主要影响因素（铁炭比、停留时间、初始pH值）。结果表明，最佳的处理条件为：铁炭比为7：3，pH值为5，停留时间为60min。在上述最佳处理条件下，对初始COD为6790mg／L的染料废水处理效率可以达到66．1％，并且废水经预处理后可生化性得到大大提高，有利于后续生化处理的进行。     

石墨炉原子吸收光谱法测定轻质油中痕量砷时样品前处理方法的探讨

研究了轻质油中痕量砷的几种样品处理方法。实验表明，石墨炉原子吸收光谱法测定时，用碘-甲苯和H2O2-HNO3相结合处理轻质油样品较为合适，萃取效率可达90％。并对影响萃取测定的其它因素作了初步探讨。     

铁屑/焦炭/H_2O_2法预处理焦化废水的试验研究

采用铁屑/焦炭/H2O2法对焦化废水进行处理,通过单因素试验法考察了铁炭比、铁炭用量、H2O2用量、废水pH以及反应时间对处理效果的影响,并确定了最适工艺条件。结果表明,铁屑/焦炭/H2O2法与常规的铁屑内电解法相比,可显著提高焦化废水的预处理效果,并缩短反应时间。铁屑/焦炭/H2O2法处理焦化废水的最适条件为:铁炭比为4,铁炭用量为300mg/L铁屑+75mg/L焦炭,H2O2用量为1000mg/L,pH为3,反应时间20min。在此条件下,COD、色度、NH3-N和CN-的去除效率分别可达61.2%、74.0%、56.2%和74.3%,B/C比由处理前的0.189提高到0.387,处理水可生化性良好。铁屑/焦炭/H2O2可作为焦化废水的一种有效的预处理方法。